Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Scion xA AutomaticFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Splices
SPLICES LOCATION
| Component | Location |
|---|---|
| B1 | In left front door. See Figure. |
| B3 | In right front door. See Figure. |
| B4 | In body harness, below left "B" pillar. See Figure. |
| B5 | In body harness, at left rear of vehicle. See Figure. |
| B6 | In body harness, left rear of vehicle. See Figure. |
| B7 | Upper left side of back door. See Figure. |
| E1 | In engine compartment harness, right side of engine compartment. See Figure. |
| E2 | In engine harness, front center of engine. See Figure. |
| E3 | In engine harness, left front of engine. See Figure. |
| E4 | Left side of engine compartment. See Figure. |
| E5 | Left side of engine compartment. See Figure. |
| I1 | Left end of dash. See Figure. |
| I2 | Left end of dash. See Figure. |
| I3 | Center of dash. See Figure. |
| I4 | Lower center of dash. See Figure. |
| I5 | Lower right side of dash. See Figure. |
| I6 | Lower center of dash. See Figure. |
| I7 | Right side of dash. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.