Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Scion xA AutomaticFACTORY OEM SERVICE PROCEDURE
BCM (Body Control Module): Consult-II: Notes
WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
CONSULT-II performs the following functions with combination of data receiving, command and transmission using the CAN communication line from the BCM.
BCM DIAGNOSTIC TEST ITEM CHART
| BCM diagnostic test item | Check item, diagnostic test mode | Content |
|---|---|---|
| Inspection by part | Work support | Changes setting of each function. |
| Self-diagnosis results | BCM performs self-diagnosis of CAN communication. | |
| Data monitor | Displays the input data of BCM in real time. | |
| Active test | Gives a drive signal to a load to check the operation. | |
| ECU part number | ECM part number can be read. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.