2010 Saturn Sky Base, StandardFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Identifying Throttle Body
    GM1578462Courtesy of GENERAL MOTORS CORP.
  1. Inspect the throttle body gasket and replace if necessary.
  2. Position the throttle body to the intake manifold.
    CAUTION: Refer to Fastener Caution .
  3. Install the throttle body bolts and tighten to 10 N.m (89 lb in).
  4. Fig 2: View Of Fuel System Electrical Connectors & Harness Clips
    GM1590626Courtesy of GENERAL MOTORS CORP.
  5. Connect the ETC electrical connector (3).
  6. Install the air cleaner outlet. Refer to Air Cleaner Outlet Resonator ReplacementΒ .
  7. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  8. Perform the throttle learn procedure. Refer to Throttle/Idle LearnΒ .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.