Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Saturn Astra XE, AutomaticFACTORY OEM SERVICE PROCEDURE
Tire Pressure Indicator Receiver Replacement/Reprogramming
When the tire pressure indicator receiver is replaced, the following procedures must be performed:
- With a scan tool, perform the Reset ECU before removing the tire pressure indicator receiver.
- After replacement, with a scan tool, perform the Program ECU and follow the screen prompts.
- Upon programming completion, test drive the vehicle above 32 km/h (20 mph) until the scan tool Learn Status data parameter is displayed as Completed.
The tire pressure monitor system should now be functioning properly.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.