Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Saturn VUE FWD L4-2.4LFACTORY OEM SERVICE PROCEDURE
Engine Control Module: Locations
Front Engine Compartment (-LAT-2.4L)
1 - Brake Fluid Level Switch
2 - Coolant Outlet
3 - Windshield Washer Fluid Level Switch
4 - Windshield Washer Fluid Pump - Rear
5 - Windshield Washer Fluid Pump - Front
6 - Windshield Wiper Motor - Front
7 - Fuse Block - Underhood
8 - Engine Control Module (ECM)
9 - Horn - Left
10 - Cooling Fan - Left
11 - Cooling Fan - Right
12 - Horn - Right
13 - Transmission Control Module (TCM)
14 - Battery
15 - Electronic Brake Control Module (EBCM)
16 - Heated Windshield Washer Nozzle - Right (XA7)
17 - Heated Windshield Washer Nozzle - Left (XA7)
Front Engine Compartment (LAT-2.4L)
1 - Brake Vacuum Sensor (HP7)
2 - Surge Tank
3 - Brake Hill Hold Valve (HP7)
4 - Brake Fluid Pressure Sensor (HP7)
5 - Electronic Brake Control Module (EBCM)
6 - Brake Fluid Level Switch
7 - Fuse Block - Underhood
8 - Engine Control Module (ECM) (LAT-2.4L)
9 - Cooling Fan
10 - Cooling Fan Resistor
11 - Transmission Control Module (TCM) (ME7)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.