Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Saturn VUE FWD L4-2.4LFACTORY OEM SERVICE PROCEDURE
Control Module HVAC: Locations
Instrument Panel/Center Console Component Views
Instrument Panel Overview
1 - Headlamp Switch
2 - Fog Lamp Switch (T37/T96)
3 - I/P Dimmer Switch
4 - Turn Signal/Multifunction Switch
5 - Instrument Panel Cluster (IPC)
6 - Steering Wheel Control Switch - Right (UK3)
7 - Windshield Wiper/Washer Switch - Front
8 - Radio
9 - Ambient Light Sensor (C67)/Sunload Sensor (C68)
10 - Speaker - Center (U61)
11 - Hazard Switch
12 - Inflatable Restraint Passenger Presence Indicator
13 - Inflatable Restraint I/P Module
14 - I/P Compartment Lamp
15 - I/P Compartment Lamp Switch
16 - Inside Air Temperature Aspirator Assembly (C68)
17 - Floor Console
18 - Rear Seat Audio Module (UUC)
19 - Traction Control Switch
20 - HVAC Control Module
21 - Windshield Wiper/Washer Switch - Rear
22 - Inflatable Restraint Steering Wheel Module
23 - Data Link Connector (DLC)
24 - Steering Wheel Control Switch - Left (UK3)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.