Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Saturn Astra XE, AutomaticFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Install the wiring harness to the fuel pump.
- Install the new gasket.
- Install the wiring harness plug to the fuel tank fuel pump module (3).
- Pull downward to fuel tank fuel pump module cover.
- Connect the 2 ground cables.
- Connect the wiring harness plug to the fuel pump.
IMPORTANT: The 2 retainers must be locked. - Install the fuel tank pressure sensor.
- Install the new gasket.
- Carefully pull downward to the fuel tank fuel pump module cover.
- Install the fuel tank sensor.
- Lock the 2 retainers.
- Carefully pull in guide downward.
- Connect the 2 wires.
IMPORTANT: The wire connectors are to be pulled in carefully for disassembling of the connection wires. - Install the fuel tank. Refer to Fuel Tank ReplacementΒ .
IMPORTANT:
Do not pull on the shaft of fuel tank sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
