Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Saturn Sky Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Scan Tool Data List
Body Control Module (BCM)
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Ignition ON, with the Engine OFF. Transmission Shift Lever in the PARK Position. | |||
| Battery Voltage Signal | BCM, Power Mode | 0-15 volts | 12 volts |
| Brake Lamp Cmd. | BCM, Chassis Data | ON/OFF | ON |
| BTSI Solenoid | BCM, Chassis Data | On/Off | Off |
Engine Control Module (ECM)/Powertrain Control Module)
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Ignition ON, with the Engine OFF. Transmission Shift Lever in the PARK Position. | |||
| Ignition 1 Signal | ECM, Engine Data | Volts | 12 V |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
