Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Saturn Sky Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Circuit/System Verification
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that RVS is enabled through vehicle personalization.
- If RVS is not enabled, use vehicle personalization to turn on RVS functionality. Refer to the vehicle owners manual.
- Verify that the keyless entry functions operate with all available keyless entry transmitters.
- If the keyless entry system does not function properly, refer to Keyless Entry System Inoperative .
- Observe the scan tool BCM Remote Start Disable History Data parameters. Verify that no Remote Start Disable History Data items are present.
- If Remote Start Disable History Data items are present, refer to the appropriate subsection in which the failure occurred.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.