Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2007 Saturn Relay 3.9 WFACTORY OEM SERVICE PROCEDURE

Object Alarm Module Replacement

WARNING: This page is about a different car, the 2007 Saturn Outlook. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Object Alarm Module

Courtesy of GENERAL MOTORS CORP.

Callout

Component Name

Preliminary Procedures

Remove the left rear quarter lower trim panel. Refer to Rear Quarter Lower Trim Panel Replacement (without RPO E61) or Rear Quarter Lower Trim Panel Replacement (with RPO E61) .
Remove the liftgate actuator (if equipped). Refer to Liftgate Actuator Replacement .

Communication Interface Module Bracket
Procedure:
Disconnect the electrical connectors.

Rear Object Alarm Module

Chapter Navigation

Return to Chapter: Repair Instructions

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.