Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Saturn Relay 3.9 WFACTORY OEM SERVICE PROCEDURE
Object Sensor - LR Middle (UD7)
WARNING: This page is about a different car, the 2007 Saturn Outlook. However, it is still accessible from the selected car via links, so may be relevant.
Object Sensor - LR Middle (UD7) Connector Parts Information
Connector Part Information
|
Terminal Part Information
|
Object Sensor - LR Middle (UD7) Connector Terminal Identification
| Pin | Wire | Circuit No. | Function |
|---|---|---|---|
| 1 | 0.35 D-BU | 2374 | Object Sensor Supply Voltage |
| 2 | 0.35 GY | 2379 | Object Sensor Low Reference |
| 3 | 0.35 OG | 2376 | LR Middle Object Sensor Signal |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.