2007 Saturn Relay 3.9 WFACTORY OEM SERVICE PROCEDURE

Object Detection Component Views

WARNING: This page is about a different car, the 2007 Saturn Outlook. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Left Rear Passenger Compartment Components
GM1863163Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Vehicle Communication Unit (VCU) (UE1)
2 Rear Parking Assist (RPA) Module (UD7)
3 Digital Radio Receiver (U2K)
4 Speaker - LR (UQA/UQ6/UQS)
5 Accessory AC/DC Power Control Module (KV1)
6 Liftgate Module (LGM) (E61)
7 G401
8 Liftgate Motor Assembly (E61)
Fig 2: Identifying Engine Components (MA5)
GM1631740Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Throttle Body
2 Camshaft Position (CMP) Sensor 1 (Intake)
3 Manual Transmission
4 Vehicle Speed Sensor (VSS)
5 Backup Lamp Switch
6 Crankshaft Position (CKP) Sensor
7 Engine Oil Pressure (EOP) Sensor
8 Starter
9 Knock Sensor Pigtail Connector
10 Generator
11 Fuel Injector Rail
12 Manifold Absolute Pressure (MAP) Sensor
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.