2007 Saturn Relay 3.9 1FACTORY OEM SERVICE PROCEDURE

Memory Seat Control Module Replacement

WARNING: This page is about a different car, the 2007 Saturn Outlook. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Memory Seat Control Module
GM1854063Courtesy of GENERAL MOTORS CORP.
Memory Seat Control Module Replacement

Callout Component Name
Preliminary Procedure:Β 
Remove the front seat. Refer to Bucket Seat Replacement .
1 Driver Seat Adjuster Memory Module Screw (Qty: 4)
NOTE: Refer to Fastener Notice .

Tighten:Β  2 N.m (18 lb in)

2 Driver Seat Adjuster Memory Module

Procedure

  1. Disconnect the electrical connector.
  2. Reprogram the module after replacement. Refer to Control Module References .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.