2007 Saturn Relay 3.9 1FACTORY OEM SERVICE PROCEDURE

Rear Body Control Module Replacement

WARNING: This page is about a different car, the 2007 Saturn Outlook. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Rear Body Control Module
GM1865182Courtesy of GENERAL MOTORS CORP.
Rear Body Control Module Replacement

Callout Component Name
1 Body Side Trim Panel Stow Compartment Door Assembly
2 Rear Body Control Module Assembly

Procedure

  1. Disconnect the electrical connectors.
  2. Reprogram the rear body control module if replaced. Refer to Control Module References .

Tip:Β  Push in the tab to release the module from the liftgate actuator assembly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.