Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Saturn Relay 3.9 1FACTORY OEM SERVICE PROCEDURE
Body Control Module (BCM) X7 (Z88)
WARNING: This page is about a different car, the 2007 Saturn Outlook. However, it is still accessible from the selected car via links, so may be relevant.
Body Control Module (BCM) X7 (Z88) Connector Parts Information
Connector Part Information
|
Terminal Part Information
|
Body Control Module (BCM) X7 (Z88) Connector Terminal Identification
| Pin | Wire | Circuit No. | Function |
|---|---|---|---|
| 1 | - | - | Not Used |
| 2 | 0.35 YE | 43 | Ignition I/II Voltage |
| 3 | 0.35 D-BU | 38 | Backup Lamp Relay Control (V92) |
| 4-5 | - | - | Not Used |
| 6 | 0.35 YE | 356 | Driver Door Lock Relay Unlock Control (AXA) |
| 7 | 0.35 L-GN | 1391 | Driver Door Unlock Relay Control |
| 8 | 0.35 D-BU | 545 | DRL Supply Voltage (TVD) |
| 9 | 0.35 L-BU | 5921 | Driver Door Unlock Relay Control |
| 10-17 | - | - | Not Used |
| 18 | 0.35 L-GN | 170 | Power Window Master Switch Right Rear Up Signal (AXC/AXE) |
| 19 | 0.35 PU | 169 | Power Window Master Switch Left Rear Down Signal (AXC/AXE) |
| 20 | - | - | Not Used |
| 21 | 0.35 D-BU | 1307 | Power Window Master Switch Lockout Signal (AXC/AXE) |
| 22 | - | - | Not Used |
| 23 | 0.35 TN | 126 | Left Front Door Open Switch Signal (AXA) |
| 24 | - | - | Not Used |
| 25 | 0.35 PU/WH | 6816 | Heated Seat Indicator Dimming (KA1-A45) |
| 26 | 0.35 PU | 171 | Power Window Master Switch Right Rear Down Signal (AXC/AXE) |
| 27 | 0.35 L-BU/WH | 280 | Power Window Master Switch Lockout Right Rear Signal (AXC/AXE) |
| 28 | 0.35 D-GN | 168 | Power Window Master Switch Left Rear Up Signal (AXC/AXE) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
