2007 Saturn Relay 3.9 1FACTORY OEM SERVICE PROCEDURE

Body Control Module (BCM) X2 (Z88)

WARNING: This page is about a different car, the 2007 Saturn Outlook. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Body Control Module (BCM) X2 (Z88) Connector End View
GM1664496Courtesy of GENERAL MOTORS CORP.
Body Control Module (BCM) X2 (Z88) Connector Parts Information

Connector Part Information 
  • OEM: 15482790
  • Service: See Catalog
  • Description: 25-Way F HIT Series (NA)
Terminal Part Information 
  • Pins: 1, 2, 3, 5
  • Terminal/Tray: SNAC-A061T-M2.8/20
  • Core/Insulation Crimp: E/A
  • Release Tool/Test Probe: 12094429/J-35616-4A (PU)
  • Pins: 8, 11, 12, 17, 18, 20, 21, 22, 25
  • Terminal/Tray: SNAC3-A021T-M0.64/20
  • Core/Insulation Crimp: J/J
  • Release Tool/Test Probe: 12094429/J-35616-64B (L-BU)
Body Control Module (BCM) X2 (Z88) Connector Terminal Identification

Pin Wire Circuit No. Function
1 0.8 OG 1732 Courtesy Lamps Supply Voltage
2 0.8 RD/WH 1240 Battery Positive Voltage
3 0.8 GY 8 Instrument Panel Lamp Supply Voltage
4 - - Not Used
5 0.8 GY/BK 690 Courtesy Lamp High Control
6-7 - - Not Used
8 0.35 BN/WH 301 Rear Park Lamps Supply Voltage
9-10 - - Not Used
11 0.35 L-GN/BK 1137 DRL Ambient Light Sensor Signal
12 0.35 WH 103 Headlamp Switch Headlamps On Signal
13-16 - - Not Used
17 0.35 D-GN 306 Headlamp Switch Headlamps Off Signal
18 0.35 PK/BK 1597 Courtesy Lamps Switch On Signal
19 - - Not Used
20 0.5 PU 5357 Right Tail Lamp Outage Detection Signal
21 0.35 BN/WH 1571 Traction Control Switch Signal
22 0.35 D-GN/WH 1135 A/T Shift Lock Control Solenoid Supply Voltage
23-24 - - Not Used
25 0.35 PU 328 Interior Lamp Switch Signal
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.