2007 Saturn Outlook XR, AWDFACTORY OEM SERVICE PROCEDURE

Rear Object Sensor Control Module

WARNING: This page is about a different car, the 2007 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Object Sensor Control Module Connector End View
GM599191Courtesy of GENERAL MOTORS CORP.
Rear Object Sensor Control Module Connector Parts Information

Connector Part Information 
  • OEM: 927690-1
  • Service: 88987946
  • Description: 26-Way F Amp MODU (BK)
Terminal Part Information 
  • Pins: 1, 2, 3, 4, 5, 6, 12, 13, 15, 18, 23, 24, 25, 26, 16, 22
  • Terminal/Tray: 104479-9/25
  • Core/Insulation Crimp: Pins 1, 2, 3, 4, 5, 6, 12, 13, 15, 18, 23, 24, 25, 26 - H/H
  • Core/Insulation Crimp: Pins 16, 22 - J/J
  • Release Tool/Test Probe: J-38125-24/J-35616-64B (L-BU)
Rear Object Sensor Control Module Connector Terminal Identification

Pin Wire Color Circuit No. Function
1 YE 2375 Left Rear Corner Object Sensor Signal
2 OG 2376 Left Rear Middle Object Sensor Signal
3 D-GN 2377 Right Rear Middle Object Sensor Signal
4 PU 2378 Right Rear Corner Object Sensor Signal
5 D-BU 2374 Object Sensor Supply Voltage
6 GY 2379 Object Sensor Low Reference
7-11 - - Not Used
12 BK 850 Ground
13 PK 1339 Run/Crank Ignition 1 Voltage
14 - - Not Used
15 L-GN 24 Back-Up Lamp Feed
16 L-GN 2525 Rear Parking Assist Module Diagnostic Signal
17 - - Not Used
18 BN 818 Vehicle Speed Signal
19-21 - - Not Used
22 L-BU 2380 Rear Parking Assist Chime Signal
23 WH 2370 Rear Parking Display Supply Voltage
24 GY 2373 Rear Parking Assist Red Indicator Control
25 D-BU 2372 Center Amber Indicator Control
26 OG 2371 Left Amber Indicator Control
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.