Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Saturn Outlook XR, AWDFACTORY OEM SERVICE PROCEDURE
Object Detection Component Views
WARNING: This page is about a different car, the 2007 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Object Sensor - LR Corner (UD7) |
| 2 | Object Sensor - LR Middle (UD7) |
| 3 | Object Sensor - RR Middle (UD7) |
| 4 | Object Sensor - RR Corner (UD7) |
| 5 | Tire Pressure Monitor Receiver - LR (UH3) |
| 6 | Tire Pressure Monitor Receiver - RR (UH3) |
| Callout | Component Name |
|---|---|
| 1 | Overhead Courtesy/Reading Lamps - Front |
| 2 | Garage Door Opener (UG1) |
| 3 | Keyless Entry Antenna - Headliner |
| 4 | Sunroof Control Module (CF5) |
| 5 | Overhead Courtesy/Reading Lamps-Rear |
| 6 | Rear Parking Assist (RPA) Display (UD7) |
| 7 | Sunroof Assembly (CF5) |
| 8 | Top of Headliner |
| 9 | Noise Compensation Microphone (UY5) |
| 10 | Sunroof Switches (CF5) |
| Callout | Component Name |
|---|---|
| 1 | Module Bracket Assembly |
| 2 | Remote Control Door Lock Receiver (RCDLR) |
| 3 | Rear Integration Module (RIM) |
| 4 | Rear Object Sensor Control Module (UD7) |
| 5 | Rear Window Shelf |
| Callout | Component Name |
|---|---|
| 1 | Rear Parking Assist Diagnostic Connector |
| 2 | Speaker Grille -LR |
| 3 | Wheel Well -LR |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
