Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2007OUTLOOK V6-3.6LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCRANKSHAFT POSITION SENSORSERVICE AND REPAIR
2007 Saturn Outlook V6-3.6L
Crankshaft Position Sensor: Service and Repair
2007 Saturn Outlook V6-3.6LSECTION Service and Repair
CRANKSHAFT POSITION SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the exhaust manifold lower heat shield.
2. Disconnect the engine wiring harness electrical connector (3) from the crankshaft position (CKP) sensor (4).
3. Remove the crankshaft sensor bolt.
4. Remove the crankshaft sensor.
INSTALLATION PROCEDURE
1. Install the crankshaft position sensor.
2. NOTE: Refer to Fastener Notice.
Install the crankshaft position sensor bolt.
Tighten the bolt to 10 N.m (89 lb in).
3. Connect the engine wiring harness electrical connector (3) to the CKP sensor (4).
4. Install the exhaust manifold lower heat shield.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.