Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2007OUTLOOK V6-3.6LREPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSERVICE AND REPAIRFRONT TOE ADJUSTMENT
2007 Saturn Outlook V6-3.6L
Front Toe Adjustment
2007 Saturn Outlook V6-3.6LSECTION Front Toe Adjustment
Front Toe Adjustment
1. Remove the power steering gear seal small clamps.
2. Verify that the steering wheel is centered and the wheels are in the straight ahead position.
3. Loosen the left and right tie rod jam nuts (2).
Important: Verify that the number of threads showing on both inner tie rod ends are approximately equal.
4. Rotate the inner tie rods in order to obtain the proper toe angle of 0 degrees.
Notice: Refer to Fastener Notice.
5. Tighten the tie rod end jam nuts.
Tighten the left and right tie rod jam nuts (2) to 68 N.m (50 lb ft).
Important: Verify that the power steering gear seal is not twisted.
6. Install the power steering gear seal small clamps.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.