Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2007OUTLOOK V6-3.6LREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY RECEIVERTESTING AND INSPECTION
2007 Saturn Outlook V6-3.6L
Keyless Entry Receiver: Testing and Inspection
2007 Saturn Outlook V6-3.6LSECTION Testing and Inspection
Remote Control Door Lock Receiver Programming and Setup
Remote Control Door Lock Receiver Replacement
If the remote control door lock receiver is replaced, the following procedures must be performed:
1. Replace remote control door lock receiver (RCDLR) Module.
2. Install Tech 2 and CANDI module.
3. Select Service Programming System and follow on screen instructions. Refer to Service Programming System (SPS). Programming and Relearning
4. With Tech 2 enter Diagnostics and build vehicle with proper Year, Make, Model and Options.
5. Select Body and Accessories.
6. Select Keyless Entry.
7. Select Module Setup, RCDLR.
8. Select Program Key Fobs. Refer to Transmitter Programming. Programming and Relearning
9. Set up a new remote control door lock receiver.
10. Select Tire Type/Pressure selection.
11. Perform Tire Pressure Sensor Learn mode-Refer to Tire Pressure Sensor Learn.
Replacing Keyless Entry Transmitters
If a keyless entry transmitter is replaced, the following procedure must be performed:
Keyless Entry Transmitter Programming-Refer to Transmitter Programming. Programming and Relearning
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.