Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Saturn ION L4-2.0L SCFACTORY OEM SERVICE PROCEDURE
Cylinder Head Assembly
Cylinder Head
Surface Flatness - Block Deck - Longitude 0.050 mm (0.002 in)
Surface Flatness - Block Deck - Overall 0.1 mm (0.004 in)
Surface Flatness - Block Deck - Transverse 0.030 mm (0.0012 in)
Cylinder Head Bolt

Install the NEW cylinder head bolts.
First Pass 30 N.m (22 lb ft)
Final Pass 155 degrees

Install the NEW front cylinder head bolts.
Tighten 35 N.m (26 lb ft)
Intake Manifold to Cylinder Head Bolt 22 N.m (16 lb ft)
Intake Manifold to Cylinder Head Nut 22 N.m (16 lb ft)
Intake Manifold to Cylinder Head Stud 6 N.m (53 lb in)
Camshaft Sprocket Bolt
First Pass 85 N.m (63 lb ft)
Final Pass 30 degrees
Camshaft Cap Bolt 10 N.m (89 lb in)
Tighten the bearing cap bolts in increments of 3 turns until they are seated.

Exhaust Manifold to Cylinder Head Nut - 2 passes 12 N.m (106 lb in)
Exhaust Manifold to Cylinder Head Stud 10 N.m (89 lb in)
Surface Flatness - Block Deck - Longitude 0.050 mm (0.002 in)
Surface Flatness - Block Deck - Overall 0.1 mm (0.004 in)
Surface Flatness - Block Deck - Transverse 0.030 mm (0.0012 in)
Cylinder Head Bolt
Install the NEW cylinder head bolts.
First Pass 30 N.m (22 lb ft)
Final Pass 155 degrees
Install the NEW front cylinder head bolts.
Tighten 35 N.m (26 lb ft)
Intake Manifold to Cylinder Head Bolt 22 N.m (16 lb ft)
Intake Manifold to Cylinder Head Nut 22 N.m (16 lb ft)
Intake Manifold to Cylinder Head Stud 6 N.m (53 lb in)
Camshaft Sprocket Bolt
First Pass 85 N.m (63 lb ft)
Final Pass 30 degrees
Camshaft Cap Bolt 10 N.m (89 lb in)
Tighten the bearing cap bolts in increments of 3 turns until they are seated.
Exhaust Manifold to Cylinder Head Nut - 2 passes 12 N.m (106 lb in)
Exhaust Manifold to Cylinder Head Stud 10 N.m (89 lb in)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
