Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Saturn ION L4-2.0L SCFACTORY OEM SERVICE PROCEDURE
Scan Tool Data Definitions
Scan Tool Data Definitions
A/C Disengage Reason
- The scan tool displays one of the following reasons why the ECM/PCM has disengaged the a/c compressor; None, System Voltage, WOT, CKP, Learn Active, Engine Run Time, Coolant Hot, Anti Stall, A/C Pressure, Engine Speed, Trans Engine Speed, A/C Pressure Sensor, Low Voltage, High Voltage, Outside Air, Temp, A/C Switched Off.
A/C High Side Pressure Sensor
- The scan tool displays 0-2951 kPa (0-428 psi). The voltage applied to the ECM/PCM input from the A/C refrigerant pressure sensor is converted to a pressure value.
A/C High Side Pressure Sensor
- The scan tool displays 0-5 volts. The voltage applied to the ECM/PCM input for the A/C refrigerant pressure sensor.
A/C Off for WOT
- The scan tool displays the high throttle disable of the a/c compressor.
A/C Pressure Disable
- The scan tool displays the status of the a/c high side pressure sensor. The scan tool displays YES/NO.
A/C Relay Command
- The scan tool displays On/Off. The scan tool displays the control decision for the compressor clutch relay output as determined by the ECM/PCM.
A/C Relay Circuit Status
- The scan tool displays the following message stating the history status of the a/c relay control circuit. The scan tool displays OK/Fault
A/C Request Signal
- The scan tool displays Yes/No. The scan tool displays Yes when the ECM/PCM receives a message to engage the A/C compressor clutch. The scan tool displays No when the ECM/PCM receives a message to disengage the A/C compressor clutch.
A/C Switch
- The scan tool displays On/Off. The a/c request switch shows current status of the a/c request switch function on the BCM.
ECT Sensor
- The scan tool displays -40 to +215°C (-40 to +419°F). The voltage applied to the ECM/PCM input from the engine coolant temperature sensor is converted to a temperature value.
Ignition 1 Signal
- The scan tool shows available voltage at the ECM/PCM. The scan tool displays 0-12 volts.
Outside Air Temp Sensor
- The voltage applied to the BCM input for the outside air temperature sensor. The scan tool displays 0-5 volts.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.