Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Saturn ION L4-2.0L SCFACTORY OEM SERVICE PROCEDURE
Brake Switch (Cruise Control): Service and Repair
Cruise Release Switch Replacement
Removal Procedure
1. Disconnect the electrical connector from the cruise control release switch.
2. Remove the cruise control release switch from the bracket.
Installation Procedure
1. Depress the brake pedal and insert the cruise control release switch into the bracket until the retainer is fully seated.
2. Connect the electrical connector to the cruise control release switch.
3. Adjust the cruise control release switch as needed. Refer to Cruise Release Switch Adjustment.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.