2007 Saturn ION L4-2.0L SCFACTORY OEM SERVICE PROCEDURE

Scan Tool Data Definitions



Scan Tool Data Definitions

Battery 1
- The scan tool displays the current state of the battery in volts.

Decoded Switch State
- The scan tool displays the current state of the decoded switch state as Undecided, Lock, Unlock, or Off.

Door Lock Switch
- The scan tool displays the current state of the door lock switch in volts.

Driver Door Switch
- The scan tool displays the current state of the drivers door ajar switch as either open or closed.

Drivers Door Unlock Fdbk.
- The scan tool displays the current state of the drivers door unlock Fdbk. as On/Off.

Fob ID
- The scan tool displays the key fob by number 1 through 4 or none, that was last used to enter the vehicle.

Lock All Doors Fdbk.
- The scan tool displays the current state of the lock all doors Fdbk. as On/Off.

Passenger Door Switch
- The scan tool displays the current state of the passengers door ajar switch as either open or closed.

RKE Lock Button
- The scan tool displays the current state of the lock button on the key fob that is being operated as On/Off.

RKE Low Battery
- The scan tool displays the current RKE low battery status as Yes/No. If the fob battery voltage falls below 2.5 volts the RKE low battery display will read YES.

RKE Panic Button
- The scan tool displays the current state of the panic button on the key fob that is being operated as On/Off.

RKE Sinc
- The scan tool displays the current state of synchronization between the key fob and the integrated body control module (IBCM) as Yes/No.

RKE Trunk Button
- The scan tool displays the current state of the trunk button on the key fob that is being operated as On/Off.

RKE Unlock Button
- The scan tool displays the current state of the unlock button on the key fob that is being operated as On/Off.

Trunk Release
- The scan tool displays the current state of the trunk release switch as On/Off.

Unlock All Doors Fdbk.
- The scan tool displays the current state of the unlock all doors Fdbk. as On/Off.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.