SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2006VUE RED LINE, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESCOMPUTER/INTEGRATING SYSTEMSCOMPONENT LOCATORCOMPUTER/INTEGRATING SYSTEMS CONNECTOR END VIEWSBODY CONTROL MODULE (BCM) C2
2006 Saturn Vue Red Line, AWD

Body Control Module (BCM) C2

2006 Saturn Vue Red Line, AWDSECTION Body Control Module (BCM) C2
Body Control Module (BCM) C2

GM73156Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12110088
  • 24-Way F Micro-Pack 100 Series (GY)
Pin Wire Color Circuit No. Function
A1 - - Not Used
A2 L-BU 1134 Park Brake Switch Signal
A3 PK 1200 Headlamp High Beam Signal
A4 - - Not Used
A5 PU 333 Brake Fluid Level Switch Signal
A6 BN 96 Windshield Wiper Switch Pulse Delay Signal
A7 - - Not Used
A8 PK 94 Windshield Washer Switch Signal
A9 RD 228 Windshield Washer Pump Control
A10 PK 339 Ignition 1 Voltage
A11 L-GN 80 Key In Ignition Switch Signal
A12 BK/WH 746 Passenger Doors Ajar Switch Signal
B1 YE 749 Security Indicator Control
B2 GY/BK 745 Left Front Door Ajar Switch Signal
B3 L-BU 292 Rear Defog Switch Signal
B4 RD/BK 744 Liftgate Ajar Switch Signal
B5 D-GN 392 Rear Window Washer Pump Control
B6 L-BU 74 Park Lamp Switch Signal (T82)
B7 OG 192 Fog Lamp Switch Signal (T96)
B8 - - Not Used
B9 YE 743 Accessory Voltage
B10 BN 9 Park Lamp Supply Voltage
B11 L-GN 1478 Coolant Level Switch Signal
B12 PU 719 Low Reference
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.