2006 Saturn Ion Red LineFACTORY OEM SERVICE PROCEDURE

Throttle Body Cleaning Procedure

CAUTION: Wear safety glasses when using compressed air in order to prevent eye injury.
  1. Remove the throttle body from the vehicle. Refer to Throttle Body Assembly ReplacementΒ .
    Fig 1: Cleaning Throttle Body & Valve
    GM1305322Courtesy of GENERAL MOTORS CORP.
  2. Open the throttle valve (3) of the throttle body (2).
  3. Use a solvent soaked cloth (1) to remove dirt or carbon deposits/buildup from the throttle valve and the throttle bore.
  4. Ensure that the throttle valve and throttle bore are clean and dry.
  5. Inspect that the throttle valve operates smoothly and freely.

    Install the throttle body to the vehicle. Refer to Throttle Body Assembly ReplacementΒ .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.