2006 Saturn Ion Red LineFACTORY OEM SERVICE PROCEDURE

Removal Procedure

Fig 1: View Of EBCM Electrical Connector
GM890987Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition switch to the OFF position.
  2. Clean the brake modulator assembly pipe fitting areas of any accumulated dirt and foreign material.
  3. Disconnect the electrical connector from the electronic brake control module (EBCM).
    Fig 2: View Of Wheel & Master Cylinder Brake Pipes
    GM890985Courtesy of GENERAL MOTORS CORP.
  4. Place a shop towel under the brake modulator assembly to catch any brake fluid loss.
    IMPORTANT: Prior to disconnecting the brake pipes from the ABS modulator assembly, note the locations of the brake pipes to the valve assembly, to aid during installation.
  5. Disconnect the caliper and wheel cylinder brake pipes (1) from the brake pressure modulator valve (BPMV).
  6. Cap the brake pipe ends to prevent brake fluid loss and contamination.
  7. Disconnect the master cylinder brake pipes (2) from the BPMV.
  8. Cap the brake pipe ends to prevent brake fluid loss and contamination.
  9. Plug the modulator brake pipe openings to prevent brake fluid loss and contamination.
    Fig 3: Locating Insulator Nuts
    GM890990Courtesy of GENERAL MOTORS CORP.
  10. Loosen the 2 insulator nuts (1) on the brake pressure modulator valve assembly.
  11. Remove the brake modulator assembly from modulator bracket by pulling straight up.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.