2005 Saturn Relay FWDFACTORY OEM SERVICE PROCEDURE

Scan Tool Data List

Body Control Module (BCM)

Scan Tool Parameter Data List Units Displayed Typical Data Value
Operating Conditions: Ignition ON, with the engine OFF. Transmission shift lever in the PARK position. Brake pedal released.
Battery Voltage Data 0-15 volts 14 volts
Brake Applied Output Outputs ON/OFF ON
BTSI Solenoid Outputs ON/OFF OFF
Ignition 1 Signal Outputs ON/OFF ON
Remote Start Input ON/OFF OFF
Powertrain Control Module (PCM)

Scan Tool Parameter Data List Units Displayed Typical Data Value
Operating Conditions: Ignition ON, with the engine OFF. Transmission shift lever in the PARK position. Brake pedal released.
Current Gear Transmission Data - -
TR Sw. A/B/C/P Transmission Data Park, Park/Reverse, Reverse, Reverse/Neutral, Neutral, Neutral/Drive 4, Drive 4, Drive 4/Drive 3, Drive 3, Drive 3/Drive 2, Drive 2, Drive 2/Drive 1, Drive 1, Invalid, Open -
TCC Brake Switch - ON/OFF OFF
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.