2005 Saturn Relay FWDFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Overhead Console Components
    GM1530702Courtesy of GENERAL MOTORS CORP.
  1. Install the OnStar® Microphone into the OnStar® button assembly. Refer to Mobile Telephone Microphone Replacement .
  2. Position the OnStar® button assembly (4) to the overhead console.
    3. NOTE: Refer to Fastener Notice .
  3. Install the screws to secure the OnStar® button assembly to the overhead console.

    Tighten:  Tighten the nuts to 2 N.m (18 lb in).

    4. Fig 2: View Of Overhead Console Mounting
    GM1530697Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connectors.
  5. Align the overhead console within the vehicle.
  6. Press up on the overhead console engaging the fasteners in order to secure the console to the vehicle.
  7. Install the overhead console screw.

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

  8. Install the courtesy lamp lens.
Chapter Navigation
Return to Chapter: OnStar Button Assembly Replacement
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.