2005 Saturn Relay FWDFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Locating Intake Air Duct Clamps From MAF Sensor & Throttle Body
    GM763014Courtesy of GENERAL MOTORS CORP.
  1. Install the air cleaner intake duct to the air cleaner housing (2) and the throttle bottle.
  2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the 2 intake air duct clamps (1).

    Tighten:Β  Tighten the clamps to 2 N.m (18 lb in).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.