2005 Saturn Relay FWDFACTORY OEM SERVICE PROCEDURE

Fastener Tightening Specifications

Fastener Tightening Specifications

Application Specification
Metric English
Catalytic Converter-to-Exhaust Manifold Bolt/Nut 31 N.m 23 lb ft
Exhaust Gas Recirculation (EGR) Pipe Bolt 10 N.m 89 lb in
Exhaust Manifold Heat Shield Bolt 10 N.m 89 lb in
Exhaust Manifold Nut 16 N.m 12 lb ft
Exhaust Pipe Clamp Nut 50 N.m 37 lb ft
Front Catalytic Converter-to-Rear Catalytic Converter Nut 31 N.m 23 lb ft
Oxygen Sensor 42 N.m 31 lb ft
Rear Catalytic Converter-to-Muffler Nut 30 N.m 22 lb ft
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.