2005 Saturn Relay FWDFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Locating Yaw Rate Sensor/Lateral Accelerometer
    GM1538732Courtesy of GENERAL MOTORS CORP.
  1. Install the yaw rate sensor (1) to the console bracket.
  2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the nuts (2) retaining the yaw rate sensor.

    Tighten:Β  Tighten the nuts to 9 N.m (80 lb in).

  4. Connect the electrical connector (3) to the yaw rate sensor.
  5. Install the front floor console reinforcement. Refer to Bracket, Reinforcement, Side Trim Panel Replacement - Front Floor Console in Instrument Panel, Gages and Console.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.