Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Saturn Relay AWDFACTORY OEM SERVICE PROCEDURE
Removal Procedure
WARNING: This page is about a different car, the 2005 Pontiac Aztek and 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper (Aztek) or Trim Pad Replacement - Instrument Panel (I/P) Upper (Rendezvous) in Instrument Panel, Gages and Console.
- Disconnect the remote control door lock receiver electrical connector (1).
- Remove the remote control door lock receiver (2) from the defroster air duct.
IMPORTANT:
Disengage the remote control door lock receiver retainers and lift upward.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.