Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2005RELAY AWDREPAIR AND DIAGNOSISELECTRICALCOMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORCIRCUIT PROTECTION DEVICES
2005 Saturn Relay AWD
Circuit Protection Devices
2005 Saturn Relay AWDSECTION Circuit Protection Devices
CIRCUIT PROTECTION DEVICES LOCATION
| Component | Location |
|---|---|
| Blower Motor Resistor Assembly | Below right side of dash, in front HVAC module. |
| Diode 3 | In engine compartment fuse box. See Figure . |
| Fuse Block - I/P | Right side of dash, behind access panel. See Figure . |
| Fuse Block - Underhood | In underhood compartment, above right front wheel well. See Figure . |
| Theft Light Emitted Diode (LED) | Center of dash, near windshield defrost vent, left of ambient light sensor. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.