Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Saturn Relay AWDFACTORY OEM SERVICE PROCEDURE
Traction Control Switch Replacement
Traction Control Switch Replacement
| Callout | Component Name |
|---|---|
|
NOTE:
Refer to Fastener Notice
in Cautions and Notices. Fastener Tightening Specifications:
Refer to Fastener Tightening Specifications
. |
|
| Traction Control Switch Replacement | |
| 1 | Panel, Instrument Panel (I/P) Accessory Trim |
| 2 | Clip, I/P Accessory Trim Panel (Qty: 5) |
| 3 | Outlet Assembly, I/P A/C Center Tip:
|
| 4 | Screw, Driver Information Center Display Switch Tighten: 2 N.m (18 lb in) |
| 5 | Switch Assembly, Traction Control |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.