Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Saturn L300FACTORY OEM SERVICE PROCEDURE
Installation Procedure
WARNING: This page is about a different car, the 2004 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
- Install the control assembly into the vehicle and install the control assembly-to-floor pan bolts. Tighten: Tighten the control assembly-to-floor pan bolts to 8 N.m (71 lb in).
- Connect the control assembly electrical connectors.
- Connect the control cable to the pin on the control assembly.
- Secure the control cable into the control assembly by pushing into place.
- Install the control cable retaining clip.
- Install the console. Refer to Console Replacement in Instrument Panel, Gages, and Console.
- Enable the SIR system. Refer to SIR Disabling and Enabling Zones in SIR.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.