2004 Saturn Vue Base, 2.2 D, AWDFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: View Of Intake Manifold Opening With A Clean Shop Towel
    GM951566Courtesy of GENERAL MOTORS CORP.
  1. Remove the shop towel from the throttle body opening.
  2. Fig 2: View Of Throttle Body Assembly & Bolts
    GM947783Courtesy of GENERAL MOTORS CORP.
  3. Install the throttle body gasket.
  4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the throttle body assembly and bolts.

    Tighten:Β  Tighten the throttle body-to-intake manifold bolts - L61 to 10 N.m (89 lb in).

  6. Fig 3: View Of Throttle Body Electrical Connector
    GM947518Courtesy of GENERAL MOTORS CORP.
  7. Connect the throttle body electrical connector.
  8. Fig 4: Identifying Outlet Resonator/Duct Assembly
    GM898897Courtesy of GENERAL MOTORS CORP.
  9. Position the outlet resonator/duct assembly into position.
  10. Connect PCV fresh air vent hose assembly.
  11. Tighten the clamp at throttle body assembly.
  12. Position the outlet resonator/duct assembly up with support bracket and install the push-pin.
  13. Tighten the clamp at the air cleaner assembly.
  14. Connect the intake air temperature (IAT) sensor connector.
  15. Turn the ignition ON for one minute while the engine control module (ECM) automatically relearns throttle position.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.