2004 Saturn Vue Base, 2.2 D, AWDFACTORY OEM SERVICE PROCEDURE

Removal Procedure

    Fig 1: View Of Ignition Control Module
    GM897621Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the intake air temperature (IAT) sensor connector.
  2. Loosen the clamp at the air cleaner assembly.
  3. Remove the push-push attachment from the outlet resonator/duct assembly to support bracket.
  4. Loosen the clamp at the throttle body assembly.
  5. Disconnect the PCV fresh air bent hose at the cam cover.
  6. Remove the outlet resonator/duct assembly.
  7. Disconnect the EI module electrical connector.
  8. Fig 2: View Of El Module & Attachment Screws
    GM896789Courtesy of GENERAL MOTORS CORP.
  9. If the module only is being replaced, remove the EI module attachment screws.
  10. Remove the ignition module attachment bolts.
  11. Fig 3: View of Ignition Module Housing Assembly With Spark Plug Boots
    GM951506Courtesy of GENERAL MOTORS CORP.
  12. Remove the ignition module housing assembly with spark plug boots.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.