2004 Saturn Vue Base, 2.2 D, AWDFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: View Of Electrical Connectors From The Primary Fuel Pump Module
    GM1226439Courtesy of GENERAL MOTORS CORP.
  1. If the fuel level sending unit is being replaced, install the fuel level sending unit onto the new fuel pump. Refer to Fuel Level Sensor Replacement - Primary .
  2. Insert the new primary fuel pump module assembly with the level sender and the new fuel pump-to-tank seal. Ensure the orientation tabs are aligned.
  3. Use the J 45722Β  to install the fuel pump lock ring. See Special Tools and EquipmentΒ .
  4. Connect the wiring harness to the primary fuel pump module and fuel tank pressure sensor.
  5. Install the secondary fuel pump module. Refer to Fuel Tank Module Replacement - Secondary .
  6. Install the fuel tank. Refer to Fuel Tank Replacement .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.