2004 Saturn Vue Base, 2.2 D, AWDFACTORY OEM SERVICE PROCEDURE

Engine Control Module (ECM) Replacement: Notes

    IMPORTANT: It is necessary to record the remaining engine oil life. If the replacement module is not programed with the remaining engine oil life, the engine oil life will default to 100%. If the replacement module is not programmed with the remaining engine oil life, the engine oil will need to be changed at 5000 km (3,000 mi) from the last engine oil change.
  1. Using a scan tool, retrieve the percentage of remaining engine oil. Record the remaining engine oil life.
  2. Fig 1: View Of Engine Control Module
    GM897621Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  4. Disconnect the intake air temperature (IAT) sensor.
  5. Loosen the clamp at the air cleaner assembly.
  6. Remove the push pin attachment from the outlet resonator/duct assembly to support bracket.
  7. Loosen the clamp at the throttle body assembly.
  8. Disconnect the PCV fresh air hose at the cam cover.
  9. Remove the outlet resonator/duct assembly.
  10. Remove the J 1 and J 2 connectors at the ECM.
  11. Remove the 4 ECM attachment bolts.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.