Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Saturn Vue Base, 2.2 D, AWDFACTORY OEM SERVICE PROCEDURE
Engine Controls Component Views
| Callout | Component Name |
|---|---|
| 1 | Spark Plugs |
| 2 | Manifold Absolute Pressure (MAP) Sensor |
| 3 | Knock Sensor (KS) |
| 4 | Crankshaft Position (CKP) Sensor |
| 5 | Engine Oil Pressure (EOP) Switch |
| 6 | Generator Mounting Location |
| 7 | A/C Compressor Clutch Location |
| 8 | Heated Oxygen Sensor (HO2S) Sensor 1 |
| 9 | Engine Coolant Temperature (ECT) Sensor |
| Callout | Component Name |
|---|---|
| 1 | Ignition Coil Housing |
| 2 | Ignition Control Module (ICM) |
| 3 | Fuel Rail and Injectors |
| 4 | Evaporative Emissions (EVAP) Canister Purge Solenoid |
| 5 | Throttle Body and Throttle Actuator Control (TAC) Module |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
