Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Saturn Ion Red LineFACTORY OEM SERVICE PROCEDURE
Installation Procedure
WARNING: This page is about a different car, the 2004 Saturn Ion 3, 2004 Saturn Ion 2, and 2004 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.
- Install the shift solenoid assembly from the shift control assembly.
- Connect the shift solenoid assembly wiring retainers to the shift control assembly.
- Install the shift solenoid retaining screw.
Tighten: Tighten the screw to 3 N.m (27 lb in).
- Install the shift indicator bulb from the shift control assembly.
- Install the shift control assembly. Refer to Shift Control Replacement in Automatic Transaxle - AF23-5 or Shift Control Replacement in Automatic Transmission - VT25-E.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.