Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2004 Saturn Ion 1 AutomaticFACTORY OEM SERVICE PROCEDURE

Removal Procedure

Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure .
Disconnect the engine fuel feed pipe from the chassis fuel flex hose. Refer to Quick Connect Fitting(s) Service (Metal Collar) .

Fig 1: Connecting/Disconnecting Fuel Feed Pipe

Courtesy of GENERAL MOTORS CORP.

Use a back up wrench on the fuel rail and disconnect the fuel feed pipe.
Remove the fuel feed pipe fastener located on the engine.
Remove the engine fuel feed pipe.

Fig 2: View Of Fuel Feed Pipe Fastener

Courtesy of GENERAL MOTORS CORP.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.