Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Saturn LW200FACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Grounds
GROUNDS LOCATION
| Component | Location |
|---|---|
| G102 | In engine compartment. |
| G103 | At left front of engine compartment, near windshield washer fluid tank. |
| G104 | Under center console. |
| G105 | At left front corner of engine compartment, forward of battery. See Figure. |
| G107 | At left front corner of engine compartment, near battery. |
| G110 | On left front of engine, near lift bracket. |
| G113 | On top center of engine. |
| G114 | At left front corner of engine compartment, near battery. |
| G118 | On front of engine block, above starter. |
| G120 | At rear of engine compartment, taped to engine harness. |
| G191 | At left side of engine compartment, near strut tower. |
| G202 | Behind lower center of dash, near radio. |
| G303 | Under center console. See Figure. |
| G304 | At left side of engine compartment, near strut tower. |
| G305 | Under center console. |
| G399 | At left rear of vehicle, near left taillight assembly. |
| G400 | Under rear shelf. |
| G401 | At left rear of vehicle, near left taillight assembly. |
| G403 | At left rear of vehicle, near left taillight assembly. |
| G463 | In top of liftgate. |
| G464 | In top of liftgate. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
