Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Saturn L200 StandardFACTORY OEM SERVICE PROCEDURE
Adjustment Procedure
WARNING: This page is about a different variant/trim than selected.
- Move the control assembly into the PARK position.
- Disconnect the control cable from the transaxle range switch lever.
- Make sure the transaxle range switch lever is in the PARK position by moving the lever counterclockwise, away from the dash panel, until it clicks and can not be moved any further.
- Release the control cable assembly adjustment lock tab at the control cable bracket on the rear powertrain mount. Use a screwdriver, awl, or pick to pry up the lock tab and lift.
- Connect the control cable end to the transaxle range switch lever.
- Press the lock tab on the control cable assembly.
- Verify proper operation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.