Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2003 Saturn L200 StandardFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Install the control boot into the indicator bezel.

Fig 1: Removing & Installing Shift Control Boot
Courtesy of GENERAL MOTORS CORP.
Install the bezel and boot over the shift lever and connect the indicator bezel electrical connector. Snap the bezel into the console opening.

Fig 2: Removing & Installing Indicator Bezel Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Install the control lever knob and the knob retainer.

Fig 3: Removing & Installing Control Lever Knob Retainer
Courtesy of GENERAL MOTORS CORP.
Install the control assembly boot onto the knob so the O-ring in the top of the boot is seated in the groove on the bottom of the knob.

Fig 4: Installing Shift Control Boot On Control Lever Knob
Courtesy of GENERAL MOTORS CORP.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.