2003 Saturn L200 AutomaticFACTORY OEM SERVICE PROCEDURE

Removal Procedure

  1. Pull the control assembly boot down to disengage the boot from the knob.
    2. Fig 1: Disengaging Shift Control Boot From Control Lever Knob
    GM893838Courtesy of GENERAL MOTORS CORP.
  2. Using a screwdriver, remove the control lever knob retainer. Remove the control lever knob.
    Fig 2: Removing & Installing Control Lever Knob Retainer
    GM893839Courtesy of GENERAL MOTORS CORP.
  3. Pull up on the control boot until the indicator bezel disengages from the console.
  4. Disconnect the indicator bezel electrical connector. Remove the bezel and boot.
    Fig 3: Removing & Installing Indicator Bezel Electrical Connector
    GM893907Courtesy of GENERAL MOTORS CORP.
  5. Disengage the control boot from the indicator bezel from the underside of the bezel. Remove the boot.
    Fig 4: Removing & Installing Shift Control Boot
    GM893886Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.