Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Saturn Ion 1 AutomaticFACTORY OEM SERVICE PROCEDURE
Anti-Lock Brake DTCS
ANTI-LOCK DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Discription |
|---|---|
| DTC C0035 | Left Front Wheel Speed Circuit Malfunction |
| DTC C0040 | Right Front Wheel Speed Circuit Malfunction |
| DTC C0041 | Right Front Wheel Speed Sensor Circuit Range/Performance (EBCM) |
| DTC C0045 | Left Rear Wheel Speed Circuit Malfunction |
| DTC C0046 | Left Rear Wheel Speed Sensor Circuit Range/Performance (EBCM) |
| DTC C0050 | Right Rear Wheel Speed Circuit Malfunction |
| DTC C0051 | LF Wheel Speed Sensor Circuit Range/Performance (EBCM) |
| DTC C0060 | Left Front ABS Solenoid #1 Circuit Malfunction |
| DTC C0065 | Left Front ABS Solenoid #2 Circuit Malfunction |
| DTC C0070 | Right Front ABS Solenoid #1 Circuit Malfunction |
| DTC C0075 | Right Front ABS Solenoid #2 Circuit Malfunction |
| DTC C0080 | Left Rear ABS Solenoid #1 Circuit Malfunction |
| DTC C0085 | Left Rear ABS Solenoid #2 Circuit Malfunction |
| DTC C0090 | Right Rear ABS Solenoid #1 Circuit Malfunction |
| DTC C0110 | Pump Motor Circuit Malfunction |
| DTC C0121 | Valve Relay Circuit Malfunction |
| DTC C0161 | ABS/TCS Brake Switch Circuit Malfunction |
| DTC C0245 | Wheel Speed Sensor Frequency Error |
| DTC C0550 | ECU Malfunction - internal write / checksum malfunction |
| DTC C0896 | Electronic Suspension Control (ESC) voltage is outside the normal range of 9 to 15.5 volts |
| DTC U1000 and U1255 | Loss of Communication |
| DTC U1300, U1301, or U1305 | Loss of Communication |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
