2003 Saturn Ion 1 AutomaticFACTORY OEM SERVICE PROCEDURE

Engine Control Module: Removal

  1. Disconnect the negative battery cable.
  2. Disconnect the small ECM harness connector from the ECM. See Figure .
  3. Remove the bolt retaining the large ECM connector to the ECM.
  4. Disconnect the large ECM harness connector from the ECM.
  5. Use the retaining tab to release the ECM from the underhood junction block bracket. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.